Page History

...

Set the ‘Authorized IP Addresses for SNMP Access’ to ‘Any IP Address’ or ‘Following IP Address’, if the latter then ensure the VSM Appliance Probe IP address is populated in one of the IP address boxes below this setting, then click ‘Apply Changes’:

Figure 1 – AES SNMP Query

Table 1 – AES SNMP Query Field Description

...

SNMP Traps are configured via the AES management portal Utilities> SNMP> SNMP Trap Receivers, then click ‘Add’:

Figure 2 – AES SNMP Trap Receivers

Populate the required fields as per the table below and then click ‘Apply changes’:

Figure 3 – AES Add SNMP Trap

Table 2 – AES SNMP Trap Field Description

...

Navigate to the Application Enablement Services Management Console then Status > Log Manager > System Logging. Select the ‘Enable Remote Logging’ checkbox, and fill in the fields as per the table below.

Figure 4 – Application Enablement Sever Syslog

Table 3 – AES Syslog Field Description

...

Select the Vendor ‘Avaya’ and Product ‘Application Enablement Server’.

Figure 5 – Web Portal – Add Equipment

...

If you are adding more than one piece of the same equipment type check the ‘Add another’ box at the bottom of the form and the bulk of the configuration will be carried over for the next item.

Table 4 – Web Portal – Add AES Field Description

Figure 6 – Web Portal - AES Configure Equipment

...

Click on the down arrow, and select the SNMP version you wish VSM to use for querying the AES:

SNMP V1 or V2

Figure 7 – Web Portal – AES SNMP V1/V2 Query

Table 5 – AES SNMP V1/V2 Field Descriptions

SNMP V3

Figure 8 – Web Portal – AES SNMP V3 Query

Table 6 – AES SNMP V3 Field Description

...

Once all fields are populated Click on the Test Access button. This will test that VSM can connect to the AES using the settings you have entered:

Figure 9 – Web Portal – ACM Test Access

...