...
Once restart is completed SNMP user configuration will be displayed with the new user configured.
SNMP V3 User Configuration
...
Navigate to Snmp >> V3 >> Notification Destination
SNMP V3 Notification Destination
Choose server >>Find>>Click Add New
SNMP Notification Destination Server Selection
...
The following page appear, from the drop down list choose Add new.
SNMP Notification Destination Configuration
SNMP Notification Destination Configuration Drop Down List
...
Syslog Severity for Remote Syslog messages >> Choose based on the requirements
CUCM Syslog configuration
...
Start the services if it was deactivated or stopped.
Control Centre – Feature Service CDR Services
...
Navigate to Cisco Unified Serviceability >> Tools >> Control Centre – Network Services >> Select Publisher from the drop down list and make sure all CDR services are up.
Control Centre – Network Services Publisher CDR Services
...
Repeat the above step for all subscribers in the Cluster.
Control Centre - Network Services Subscriber CDR Service
...
Navigate to Cisco Unified CM Administration >> System >> Service Parameter >> Call Manager Service. Set the CDR Enabled Flag to True. This has to be done for all the nodes in the server.
CUCM Service Parameters Configuration
Set up CDR Enabled Flag and CDR Log Calls with Duration to True
...
navigate to System >> Service Parameter >> Call Manager Service>> Clusterwide Parameters >> Call Diagnostics Enabled parameter to Enabled Only When CDR Enabled Flag is True
Setup Call Diagnostics – Enable CMR
...
Now add SFTP server/Billing Server where the files are to be sent. Navigate to Cisco Unified Serviceability > Tools > CDR Management and add new billing server.
CDR Management Page
...
Field | Value |
Host Name /IP Address | Enter Probe IP server |
Username | Enter username details for SFTP |
Password | Enter Password details for SFTP |
Protocol | SFTP |
Directory Path | \ |
Resend on Failure | Check the checkbox |
Billing Application Server Parameters
...
Navigate Disaster Recovery System
Navigate to Backup >> Backup Device >> Add New
Disaster Recovery Page
...
If using CUCM prior to Version 12.0, the features are CDR_CAR, UCM and PLM. If using CUCM Version 12.0 and later, the features are CDR_CAR, UCM and IM_AND_PRESENCE.
CUCM Backup features prior to Version 12.0
CUCM Backup features for Version 12.0 and later
...
Configure a schedule backup based on your scenario, recommended Daily backup after hours.
Backup Schedule
...
Once the Backup Schedule is created, click on Enable Schedule
Enable Schedule
...
Make sure the schedule status is changed to Enabled.
Schedule Backup Enabled
...