...
VSM Express Raspberry Pi resource requirements
Item | Specification |
---|---|
CPU | Raspberry Pi 2 Model B or Raspberry Pi 3 Model B |
Power supply | 5V micro USB power supply 1.2A (1200mA) |
Micro SD Card | 8gb class 8 or higher |
Case | Specific fully enclosed case for Raspberry Pi |
Installation
Installation of the Raspberry Pi appliance is comprised of two parts:
...
Raspberry Pi SSH Credentials
Username | Password |
administrator | Administrator |
Raspberry Pi SSH Login
After entering the credentials you will be given the Debian command prompt:
...
Raspberry Pi Static IP Address Details
Line | Value |
address | The IP address you want VSM Express to assume (in the proper range for you network). Note: Pay attention to not use an IP already used by another device in your LAN or that can be assigned to another device by your router via DHCP |
netmask | 255.255.255.0 |
network | Same format as your IP address but usually ends in .0 Note: If for example your LAN is configured to have IP addresses in the range x.x.x.1 to x.x.x.255, you will put x.x.x.0 in the network line. |
broadcast | Same format as your IP address but ends in 255 |
gateway | This is usually your router IP |
Raspberry Pi 2 Model B Network Interfaces Example
...
Raspberry Pi 3 static IP address details
Line | Value |
Interface | This defines which network interface you are setting the configuration for, eth0 = wired, wlan0 = wireless. |
Static ip_address | The IP address you want VSM Express to assume (in the proper range for your network). Note: Pay attention to not use an IP already used by another device in your LAN or that can be assigned to another device by your router via DHCP (Make sure you leave the /24 at the end) |
Static routers | This is the IP address of your default gateway |
Static domain_name_servers | This is the IP address of your DNS |
Once complete press ‘ctrl-X’ to exit the nano editor:
...